tuned-amdgpu/roles/tuned_amdgpu/templates/amdgpu-profile-overclock.sh.j2

#!/bin/bash
{{ ansible_managed | comment }}
# This is the 'overclock' script; applies amdgpu clock/power/voltage tunables
#
# AMDGPU driver/sysfs references:
#   https://01.org/linuxgraphics/gfx-docs/drm/gpu/amdgpu.html
#   https://docs.kernel.org/gpu/amdgpu/thermal.html
#
# start by including the 'common' script; determines card/hwmon dir/power profiles/power capability
. $(dirname "${BASH_SOURCE[0]}")/amdgpu-common.sh

{# begin the templated script for 'overclocked' AMD GPU profiles based on the existing tuned profiles #}
# set the minimum GPU clock - for best performance, this should be near the maximum
# RX6000 series power management *sucks*
echo 's 0 {{ gpu_clock_min }}' | tee /sys/class/drm/"${CARD}"/device/pp_od_clk_voltage

# set the maximum GPU clock
echo 's 1 {{ gpu_clock_max }}' | tee /sys/class/drm/"${CARD}"/device/pp_od_clk_voltage

# set the GPU *memory* clock
# normally this would appear disregarded, memory clocked at the minimum allowed by the overdrive (OD) range
# it follows the core clock; if both 0/1 profiles for _it_ are high enough, the memory will follow
echo 'm 1 {{ gpumem_clock_static }}' | tee /sys/class/drm/"${CARD}"/device/pp_od_clk_voltage
{% if gpu_mv_offset is defined %}

# offset GPU voltage {{ gpu_mv_offset }}mV
echo 'vo {{ gpu_mv_offset }}' | tee /sys/class/drm/"${CARD}"/device/pp_od_clk_voltage
{% endif %}

# commit the changes
echo 'c' | tee /sys/class/drm/"${CARD}"/device/pp_od_clk_voltage

# force GPU core and memory into highest clocks (fix flickering and poor power management)
# set manual control mode
#   allows control via 'pp_dpm_mclk', 'pp_dpm_sclk', 'pp_dpm_pcie', 'pp_dpm_fclk', and 'pp_power_profile_mode' files
echo 'manual' | tee /sys/class/drm/"${CARD}"/device/power_dpm_force_performance_level

# adjust power limit using multiplier against board capability
POWER_LIM_OC=$(/usr/bin/awk -v m="$POWER_CAP" -v n={{ gpu_power_multi.overclock }} 'BEGIN {printf "%.0f", (m*n)}')
echo "$POWER_LIM_OC" | tee "${HWMON_DIR}/power1_cap"

# avoid display flickering, force OC'd memory to highest clock
echo '3' | tee /sys/class/drm/"${CARD}"/device/pp_dpm_mclk

# extract the VR power profile ID number
PROF_VR_NUM=$(/usr/bin/awk '$0 ~ /VR.*:/ {print $1}' <<< "$PROFILE_MODES")

# force 'overclocked' profile to 'VR' power/clock heuristics
# latency/frame timing seemed favorable with relatively-close minimum clocks
echo "${PROF_VR_NUM}" | tee /sys/class/drm/"${CARD}"/device/pp_power_profile_mode